Nissan SR20 S13,S14,S15 Crank Trigger Kit.
This is the latest in our range of complete Harmonic balancer / trigger kit packages.
This kit is made up of:-
1. MJ race Harmonic Balancer tested to 12,000 rpm bonded with lifetime warranty.
2. 36 minus 2 trigger wheel.
3. Billet crank sensor mount with sensor.
The picture shows a balancer mounted with an oil pump drive for a dry sump with 19 tooth gear.
The trigger kit is designed to mount with and clear an external oil pump or dry sump pump using our bracket and Aviaid oil pump.
We also have a signal converter box that will allow you to run our trigger/sensor kit with standard Nissan ECU.
For Your
Nissan SR20 S13,S14,S15 Crank Trigger Kit
Contact Ross Performance Parts
or Call Australia 61 2 9676 1466
Nissan Skyline RB Crank Trigger Kit Installation
NISSAN RB CRANK TRIGGER KIT
#part number 306202-79
 |
The clearance between the trigger wheel and the crank angle sensor should be between 1.02mm – 2.03mmThis height can be adjusted by inserting 6mm flat washers between the sump rail and the crank angle sensor mount.You will need to use 3x 6mm flat washers that are provided in the kit under the heads of the cam angle sensor retaining bolts.You will notice that Top Dead Centre (TDC) is located on the spike that has been coloured white – you will also see a line on the spike to indicate this. |
Installation of Cam sensor cover.
1 Remove std CAS from the engine then remove the top cam belt cover.
2 Remove the alloy mounting bracket and remove the 4 cam pulley mounting bolts and plate.
3 Install cam sensor drive shaft with the longer M7 bolts supplied.
4 Replace alloy bracket and belt cover
5 Mount new cam sensor cover with 3 M6 cap screws supplied.
Crank trigger Fastener List
M6 x 75 socket cap screw x 2
M6 x 50 socket cap screw x 1
M6 x 10 socket cap screw x 1
Cam Sensor fastener List
M6 x 25 socket cap screw x 3
M6 hardened washer x 3
M6 x 10 socket head cap screw.
M7 x 25 hex bolts x 4
Nissan Twin Cam Trigger Kit
Contact Ross Performance Parts
or Call Australia 61 2 9676 1466
Nissan Skyline Twin Cam Trigger Kit
THIS IS OUR COMPLETE CAM AND CRANK TRIGGER SET UP FOR THE GTR OR TWIN CAM NISSAN
Featured in this picture from left to right is, metaljacket balancer with trigger wheel mounted and an oil pump drive and gear, the crank sensor mount with sensor inserted .
This billet bracket mounts under the oil pump on the pan rail. The shaft standing up is the cam sensor trigger and the cam sensor mount is seen mounted to the timing cover.
This complete kit is a simple mount up job and a small amount of electrical work. It is designed to run with most aftermarket ECUs.
When fitted and tuned you will notice an immediate change in the engine performance and sound.
There is no need for the engine tuner the retard the timing because of the scatter in the maps from the vibration in the old belt and CAS set up. Our kit is stable and your dyno graph line will be straight from idle, all the way to the rev limiter.